Monkey loop MLA-10GT Manual De Usuario

USER'S MANUAL
MONKEY LOOP
MLA-10GT
PRECAUTIONS
Location
Using the unit in the following locations can result in a malfunction.
- In direct sunlight
- Locations of extreme temperature or humidity
- Excessively dusty or dirty locations
- Locations of excessive vibration
- Close to magnetic fields
Power supply
Be sure to turn the power OFF when the unit is not in use. Remove the battery in order to
prevent it from leaking when the unit is not in use for extended periods. If using a power
adapter, please connect the designated AC adapter to an AC outlet of the correct voltage.
Do not connectit to an AC outlet of voltage other than that for which your unit is intended.
Interference with other electrical devices
Radios and televisions placed nearby may experience reception interference. Operate this
unit at a suitable distance from radios and televisions.
Handling
To avoid breakage, do not apply excessive force to the switches or controls.
Care
If the exterior becomes dirty, wipe it with a clean, dry cloth. Do not use liquid cleaners such
as benzene or thinner, or cleaning compounds of flammable polishes.
Keep this manual
After reading this manual, please keep it for later reference.
Keeping foreign matter out of your equipment
Never set any container with liquid in it near this equipment. If liquid gets into the
equipment, it could cause a breakdown, fire, or electrical shock. Be careful not to let metal
objects get into the equipment.
CONTROLS AND FUNCTIONS
MLA-10GT
MONKEY LOOP
1. Guitar Connect: Link to an electric guitar by guitar cable
2. Distortion Button: Select clean sound or distortion sound (Press to select distortion
effect)
3. Gain Knob: Adjust distortion level (works only when distortion effect selected)
4. Bass Knob: Adjust bass frequencies
5. Treble Knob: Adjust treble frequencies
6. Volume Knob: Adjust main volume
7. LED Light: Power indicator
8. Power Switch: Switch On/Off power. Power indicator is lit when power ON.
9. Power In: AC 12V adapter input
10. AUX Volume Control: Adjust AUX music volume
11. AUX In: Connect to a 3.5mm gauge audio cable
12. Battery Compartment: Load 6 AA batteries.
Remind: When AC 12V adapter is connected, the batteries power is cut off. When the
adapter link off, the batteries power is connected automatically again.
BATTERY LOAD
Please follow the next steps to load or replace batteries:
1. Press the buckle and pull out to open the battery compartment lid as shown by diagram
①②.
2. Insert two batteries according to the polarity direction marked as shown by diagram ③
And then press the joint area as shown by diagram 4 to load batteries successfully.
3. Load all the other four batteries following step 2 and cover the battery compartment lid.
SPECIFICATIONS
Max. output :10W
Speaker spec: 5 inch, 8n
Power : 6 AA batteries, or enclosed AC adapter
Dimension : 238x179X224mm
Net weight : 2.75kg
Accessories : AC adapter ( DC12V/1A
FCC Warning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if notinstalled and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which there ceiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to
operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2)this device must accept any interference received, including interference that
may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm between the radiator & your body
), manual, 3.5mm gauge audio cable.