Network
While in System Settings Mode, press 1 2 w s 3 buttons to select Network.
1.
Press the SELECT button to confirm.
2.
Press 1 2 w s 3 buttons to select from the following settings, then press the
SELECT button to confirm.
Press the BACK button on the unit or remote control to cancel the setting and
3.
return to the previous menu.
Network Wizard
PBC WLAN Setup
View Settings
Manual Settings
NetRemote PIN Setup
Network Profile
Clear Network
Settings
Keep network
connected
System Settings
SSID – select the desired wireless network. Rescan –
Scan for available networks.
Manual config – Select wireless network with DHCP
(Dynamic Host Configuration Protocol)
enable/disable.
Select WPS on the unit and press the WPS button on
the modem device that you wish to connect with.
Press SCROLL/SELECT dial on unit or SELECT button
on remote control to continue.
Display the settings on the unit.
Select wireless network with DHCP enable/disable.
To define a PIN number to be entered before being
able to connect to the unit remotely over a network.
View the connected network.
To delete the connected network memory in Network
profile.
To define whether remains connected to its network
in Standby mode and when not in Network radio
mode.
EN
13