Black and Decker ALIGATOR LP1000 Manual De Instrucciones página 13

FREE
WARNING LABEL REPLACEMENT: If your warning labels
become illegible or are missing, call 1-800-544-6986 for a free
replacement.
Troubleshooting Section
If your saw does not operate correctly check the following:
Problem
• Tool will not
start.
• Bar / chain •
overheated.
• Chain is loose. •
• Poor cut qualit
• Unit runs but •
does not cut.
Possible Cause
• Fuse blown or
breaker tripped.
• Extension cord not
plugged in.
Chain too tight.
Lubrication
needed.
Chain tension set
incorrectly.
Chain tension set
incorrectly.
Chain needs
replacement.
Chain installed
backwards. See
page 10 for
illustration.
Chain installed?
Possible Solution
Check fuse or breaker.
Check to make sure
extension cord is plugged
into a workinq outlet.
Refer to section on
adjusting chain tension.
Refer to sections for chain
oiling application.
Refer to section for chain
tensioning.
Refer to section on
adjusting chain tension.
Note: Excessive tension
leads to excessive wear
and reduction in life of bar
& chain. Lubricate after
every 10 minutes of use.
Refer to section for
installation of chain.
Refer to sections for
installing and removing
chain.
Black & Decker (U.S.) Inc.
701 E. Joppa Rd.
Towson MD 21286 U.S.A.
13
See 'Tools-Electric' I_1
- Yellow Pages -
for Service & Sales