neno Perla Twin Manual Del Usuario página 15

of scalding the baby's face.
3. Thaw the milk in the fridge overnight. Do not refreeze milk once thawed.
You can thaw milk quickly by holding it under running water at a maximum
temperature of 37°C.
4. Place the sealed bottle/bag in a bowl of warm water for 20 minutes to bring
the milk to body temperature.
5. Do not add freshly drained milk to previously frozen milk if the amount of
fresh milk exceeds the amount of previously frozen milk.
10. REPLACEMENT OF CONSUMABLES
Consumable components are subject to natural wear and tear during operation of
the breast pump and are therefore not covered by the manufacturer's warranty.
Worn components of the breast pump that come into contact with milk should
be replaced. A worn component has a crack, deformation, tarnishing or a distinct
change in colour.
- The membrane should be replaced every 8 weeks (if you use the breast pump
1-3 times a day) or every 3-4 weeks (if you use the breast pump more than 3 times
a day).
- The valve should be replaced every 2-3 months (if you use the breast pump 1-3
times a day) or every 4 weeks (if you use the breast pump more than 3 times a day).
- The breast shield and connector should be replaced every 6 months if you use the
breast pump more than 3 times a day.
11. LONG-TERM STORAGE
The breast pump has a built-in rechargeable battery. To protect itself from damage,
the device enters storage mode after a long period of inactivity. To deactivate the
storage mode, connect the device to power and charge it for 2 hours. Before you
put the breast pump away for a long period of time, make sure that:
• All components of the breast pump are clean.
• You have cleaned the pumping device.
• The device's battery is fully charged.
12. FAQ
1. If the unit does not start: make sure that the breast pump is plugged into a
functioning socket. If the breast pump has no power source, the display will
not switch on and no error message will appear.
2. No/poor suction: make sure all breast pump parts are positioned correctly.
Take the breast pump apart and make sure all parts are clean and unda-
maged. Reassemble the breast pump according to the instructions in the
LACTATOR ASSEMBLY section. When pumping, make sure the funnel is fully
seated against the breast.
15