Publicidad
•
Always provide enough, but safe, distance between the child and the
tray.
•
Be careful when adjusting the position of the tray, the footrest and
when unfolding or folding the chair, as there is a risk of pinching your
fingers.
•
Use the tray always in combination with safety belts! The tray is not
intended to protect the child from falling.
•
Never lift, move, fold, adjust or repair the seat when there is a child in
it. This can injure the child.
•
Always before use, check the functioning of the locking mechanisms.
•
Before placing the child in the seat, make sure that it is fully unfolded
and locked in the open position and that all locking mechanisms are
tightly closed! This will prevent the child from being injured by sudden
folding of the chair.
IMPORTANT! The diagrams and figures in this instruction are illustrative and
indicative only. Check the securing of the fixation after each operation.
Components – PD
1. Chair backrest; 2. Tray adjustment button; 3. 5-point seat belt; 4. Upper
support tubes (legs); 5. Seat board; 6. Lower support tubes (legs); 7. Footrest;
8. Fold/Unfold button; 9. Restrictor on the feeding tray; 10. Feeding tray
Assembly of the structure
WARNING! Make sure that the base is assembled correctly and is stable, this
ensures the safety of your child!
Strictly follow the instructions and sequence for assembling the product as
shown in the diagrams.
1. Turn the seat board (5) on a flat surface. Insert the upper support tubes (4)
into the corresponding holes on the seat board. Push until you hear a clicking
sound and the spring-loaded tabs tighten and pop out of their holes (Figure A).
2. Connect the lower support tubes (6) to the upper tubes assembled to the
seat. Push until you hear a clicking sound and the spring-loaded tabs tighten
and pop out of their holes (Figure B).
3. To unfold the seat board (5), press both side buttons (8) simultaneously to
fold/unfold the seat (Figure C ).
ASSEMBLY AND EXPLOITATION
19
Publicidad
