Troubleshooting - Hegrom STILKAMIN S-460 Instrucciones Para Instalación, Uso Y Mantenimiento

11 - TROUBLESHOOTING

What to do if... ?
Problem
1. Soot covers the ceramic glass too
quickly
2. The fireplace does not feature a
regular draft
3. Combustion in the fireplace is not
correct
4. The fireplace releases strong smells
or fumes
5. Release of fumes when adding fuel
and during heating
If these indications are not enough to solve the problems, contact your authorized reseller or chimneysweep
service.
Cause
Not enough draft
Wrong adjustment
Excessive quantity of Wet firewood
Inappropriate fuel
Not enough draft in the fireplace
The stove is full of soot inside
Atmospheric conditions influx
Incorrect lighting
Heating phase
Not enough draft of the fireplace,
the connection of the tube for the
outlet of fumes is not sealed
23
Solution
General observations:
From time to time (according to the
frequency of use) it is necessary
to clean the ceramic glass with a
specific detergent for fireplaces
Refer to the chimneysweep service
(it may be necessary to extend the
flue or modify the lining of the
chimney)
Adjust air intakes as indicated in
these instructions (if secondary air
inlet is closed, soot accumulates
faster on the glass, while with a
correct adjustment it could clean by
itself)
Refer to the "fuel maximum quality"
section
Refer to the "clean combustion"
section; you can
compressed wood logs (they are
usually uniformly dry)
Or: with the use of lignite blocks
the glass gets dirty faster than with
firewood
Refer to the "Short information on
materials and ways of combustion"
section.
Refer to the "Maintenance and
cleaning" section
Refer to the "Fire lighting" section
Refer to the "Fire lighting" section
Refer to the "Openings
convection air" section
Check the connection points
also use
for