1, Unplug cord from wall outleL DO NOT
drip water on cleaner.
2, Clean exterior using a clean, soft cloth
that has been dipped in a solution of mild
liquid detergent
and water, then wrung dry,
Wipe dry after cleaning.
3o To reduce static electricity
and dust build-
up, wipe outer surface of cleaner and
attachments.
Check motor safety filter occasionally
and
E
........ "'
#
N
CAUTIO
Do not use attachments
if they are
wet.
Attachments
used in dirty
areas, such as under a refrigerator,
should
not be used on other
surfaces
until they are washed,They
could
leave marks.
I
I
11111, _1 ii1,111,1=,,i,1,,i'
, i
change when dirty.
!.13 ......
Electrical
Shock
Hazard
Unplug
power
cord from electrical
outlet.
Do not operate
the cleaner
without
the motor safety filter.
Be
sure the filter is dry and properly
installed
to prevent motor
failure
and/or
electrical
shock.
Remove the bag as outlined in the BAG
CHANGING
section°
MOTOR SAFETY
FILTER
ELECTROSTATIC
This white and grey filter must be replaced
when dirty
It should be replaced regularly
depending
on use conditions,
The filter
CANNOT
be washed
as it will lose its
dust trapping
ability.
NOTE: Use motor safety filter #20-86883,,
In Canada, #20-86883C.
1. Lift the rubber
retainer and pull
out motor safety
filter as shown.
fA\" f
i/M,,
!
2. Replace the fil-
ter, white side out,
by sliding it back
into place under
the ribs in the bag
cavity. Tuck filter in
so that it fits com-
pletely under the
rubber retainer,
3. Replace the bag as outlined
in the BAG
CHANGING
section.
,i CAUTION
NEVER REUSE A DUST BAG. Very
fine materials,
such as carpet fresh-
ener, face powder, fine dust, plaster,
soot, new carpet lint, etc. can clog
the bag and cause it to burst
before
it is full and may cause damage to
vacuum
motor,
Change bag more
often when vacuuming
these materi-
als.
16