Publicidad
Idiomas disponibles
Idiomas disponibles
MOUNTING PROCEDURES
Locate the wall mounting location for the EVSE:
•
On the hardwired HCS-D, the three service conductors are
shielded by three feet of flexible conduit at the bottom of the
unit. The HCS-D must be positioned such that this conduit
can reach a nearby junction box.
•
On the plug-in HCS-D, the NEMA plug head is connected
by 6 feet (1.8 m) of cable (including the plug head) to the
bottom side of the HCS-D. The plug-in HCS-D must be
positioned such that this plug can safely be inserted into a
wall-mounted NEMA socket. Do not allow the power supply
cord to contact the floor when plugged into the outlet.
•
Position the bottom of the EVSE at a comfortable height and
at least 18" above the ground for indoor installations and
24" off the ground for outdoor installations. Ensure that the
front panel indicators of the EVSE can clearly be seen by
the user of the device.
•
The HCS-D has two vertically aligned mounting holes
spaced 17" apart, one each on the enclosure top and bottom.
Use a ruler or template to mark hole locations on the
mounting surface.
WARNING: For safety, always turn off input power to the
EVSE at the circuit breaker panel prior to plugging it in or
wiring it to the service lines. Likewise, turn off the circuit
breaker prior to unplugging it or disconnecting the unit from
the service lines.
HCS-D User Manual
17
Publicidad
