Behncke B050 Ultimate Instrucciones De Operación página 23

7.2 Mounting to concrete pools
Tiled or with foil lining
Mark the desired water level (normal water level) on the casing towards the inside of the pool in order to
align the enclosed drilling template. The holes must be made using centre punches in accordance with the
instructions on the drilling template and drilled with drill bit appropriate to the casing material.
7.2.1 Installation diagram for concrete pools
Skimmer cover
Concrete pool installation situation
NOTE
Place the surface suction unit behind the casing and attach in the desired
position (using plastic-coated wires, stable round cord or wooden slats).
When installing the surface suction unit, it must be ensured that there is
contact with the sheathing.
Check whether the protective cover is attached to the surface suction unit.
Secure the surface suction unit using the 4 screws enclosed. To do this,
press the surface suction unit into place from the inside of the pool, align it
horizontally using a spirit level, and then screw in the screws.
The connecting line to the surface suction unit for the suction (if necessary, the
connection with the floor drain too), the filling water supply feed and overflow
are to be tightly connected or glued in by a professional and guided out of the
back of the casing (outer wall side of the pool). (Curing and setting times must
be observed)
Tile
Casing
Surface Suction Unit Ultimate / Planning information
Mortar layer
Water line
M6 hexagon screw
for casing
Casing
Concrete
6