Publicidad
Idiomas disponibles
Idiomas disponibles
72" STANDARD INSTALLATION
CASE TRIM INSTALLATION
Install the trim kit side rails to the exposed right and
left case walls using the provided #8 Phillips head
screws -
8
screws per side.
Loosen top cover hex head screws, so you can slide
the top trim slots between the hex head screws and
the top cover.
Fit the top trim and side trim rails together by sliding
the exposed edges of the corner trim into the right
and left trim kit side rails. Align and drive the two
number
8-32 Phillips head screws
bosses in the side rails to ensure the top trim is
snugly fit to the side rails.
Tighten the top cover hex head screws, so the top
trim is secured to the cabinet.
31-1000725 Rev. 2
Installation Instructions
into the screw
TOE KICK INSTALLATION
Create a custom toe kick or purchase Stainless Steel
Toe Kick ZKK72R.
A toe kick magnet can be found in the box of
parts that was taped to the side of each of the
refrigerators.
These will be used for custom toe kicks
only.
For custom toe kicks, adhere magnets to the back
side of the toe kick. The surface of the toe kick where
the magnets are to be placed must be clean and free
of foreign material. Center magnets vertically and
horizontally.
Position toe kick on bottom portion of front access
covers.
FOLLOW ALL INSTALLATION INSTRUCTIONS
PROVIDED WITH THE APPLIANCE TO COMPLETE THE
DUAL INSTALLATION
7
Publicidad
