peerless-AV PLA60-UNL Instalación Y Ensamblaje página 11

For Flat Back Display
Begin with the shortest length screw, hand thread through multi-washer and adapter bracket into display as shown
7-1
below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do not overtighten.
If screw cannot make three full turns into the display, select a longer length screw from the baffled fastener pack.
Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of display.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Bump-out or Recessed Back Display
Begin with longer length screw, hand thread through multi-washer, adapter bracket and spacer in that order into
7-2
display as shown below. Screw must make at least three full turns into the mounting hole and fit snug into place.
Do not overtighten. If screw cannot make three full turns into the display, select a longer length screw from the
baffled fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
DISPLAY
ADAPTER
BRACKET
(BB)
DISPLAY
SPACER
11 of 40
fig. 7.1
MULTI-WASHER
SCREW
fig. 7.2
MULTI-WASHER
SCREW
ADAPTER
BRACKET
(BB)
ISSUED: 2006-05-06 SHEET #: 202-9141-14 (2023-01-31)