Intel® Optane; Intel® Optane™ Setup Procedure - bto X-Book 15CL71 Guía De Usuario

Intel® Optane™
Intel® Optane™ is a combination of a compatible mem-
ory device and Intel Rapid Storage Technology soft-
ware. This combination is designed to speed up your
system performance by caching boot data, executables,
frequently accessed data and system page files to an non
volatile, low latency Intel® Optane™ SSD.
Contact your distributor or supplier to see if your system
supports this technology.
If you are reinstalling a system that has previously been
setup in Intel RST Premium mode, make sure you have
cleared the Intel Optane Memory (see
Optane™ on page 7).
Intel® Optane™ Setup Procedure
You need to setup Intel Optane™ before installing your
®
Windows 10 operating system, and you will need to pre-
pare the following in order to do so.
• The Microsoft Windows 10 OS DVD.
• An attached external DVD drive.
• An Intel® Optane™ SSD installed in your system.
• The Device Drivers & Utilities + User's Manual disc.
1. Start-up your notebook computer and press <F2> to enter the
BIOS.
2. Go to the Boot menu, select UEFI Setting and press <Enter>.
3. Set UEFI Boot to "Enabled".
6
4. Press <Esc> to exit the menu and go to the Main menu.
5. Select OffBoard NVMe Controller Configuration and press
<Enter> to check that an Intel® Optane™ SSD is present.
6. Press <Esc> to exit the menu and go to the Advanced menu.
7. Select SATA Mode, press <Enter> and select "Intel RST
Premium".
8. Press <F4> and <Yes> to "Save Changes and Reset".
9. As the computer restarts press <F2> to enter the BIOS again.
Clearing Intel®
10. Press <F4> and <Yes> to "Save Changes and Reset",
however ensure that the condition in the bulleted point
below is met before doing so.
• Make sure the Windows 10 OS DVD is in the attached
DVD drive, as the computer starts up it will automatically
boot from the Windows 10 OS DVD (you will be
prompted to press a key to boot from the DVD).
11. Click Next > Install Now to continue installing the operating
system as normal (see your Windows documentation if you
need help on installing the Windows OS).
12. Select Custom: Install Windows only (advanced).
13. It is recommended that you select and then delete existing
partitions.
14. Click New to create a partition for Windows.
15. It is very important to make sure that when you create the
partition, leave at least a minimum of unallocated space of
5MB.