Husky H4822 Manual De Instrucciones De Operación Y Lista De Partes

Operation & Parts Manual
3/8" Reversible Drill
Table of Contents
•
Specifications
•
General Safety Information
•
Features & Operation
•
Maintenance
•
Parts List
•
Warranty
Specifications
Free speed (No Load) ................................................. 1,800 RPM
Spindle thread ................................................................. 3/8" - 24
Weight ............................................................................... 2.4 lbs.
Length ................................................................................. 6-1/2"
Recommended hose size ................................................ 3/8" I.D.
Average air consumption ................................................... 4 CFM
Air inlet ........................................................................... 1/4" NPT
Maximum Air Pressure ....................................................... 90 PSI
General Safety Information
Read Operating Instructions
Always become familiar with all the instructions and
warnings before operating any pneumatic tool.
Always Wear Approved Eye Protection Impact
resistant eye protection should meet or exceed the
standards as set forth in the United States ANSI Z87.1,
Occupational and Educational Eye and Face Protection.
Look for the marking Z87.1 on your eye protection to
insure that it is an approved style. For further
information, ANSI Z87.1, Occupational and Educational
Eye and Face Protection, is available from the American
National Standards Institute, Inc., 11 West 42nd Street,
New York, NY 10036.
Hearing Protection is Recommended
Hearing protection should be used when the noise level
exposure equals or exceeds an 8 hour time-weighted
average sound level of 85dBA. Process noise, reflective
surfaces, other tools being operated nearby, all add to
the noise level present in your work area. If you are
unable to determine your noise level exposure, we
recommend the use of hearing protection.
Sold Exclusively at The Home Depot
2455 Paces Ferry Road, Atlanta, Georgia 30339
Description
The Husky model no. H4822 3/8" Reversible Drill is
designed for applications which include drilling, honing, wire
brushing, tapping and fastening of screws. This tool features
a side mounted reverse lever for quick and easy direction
changes.
Avoid Prolonged Exposure to Vibration
Pneumatic tools can vibrate during use. Prolonged
exposure to vibration or very repetitive hand and arm
movements, can cause injury. Stop using any tool if
discomfort, tingling feeling or pain occurs. You should
consult your physician before resuming use of the tool.
90 PSIG Maximum
Husky air drills are designed to operate at an air pressure
of 90 pounds per square inch gauge pressure (90 PSIG)
maximum, at the tool. Use of higher air pressure can, and
may cause injury. Also use of higher air pressure places
the internal components under loads and stresses they
were not designed for, causing premature tool failure.
The air supply should be clean and dry, preferably
lubricated. For best results drain the moisture from your
compressor daily.
Use Proper Accessories
Always disconnect tool from air supply before changing
accessories. Never hold work in hands, lap or against
other parts of the body. Secure all work with clamps or a
vice so that both hands are free to operate tool. Keep
proper footing and balance at all times. Verify tool
direction before starting. Do not change direction of tool
while tool is running.
Model No. H4822
PL-0713