Goodwe SCU3000-S Guía De Instalación Rápida página 3

01 Safety Precautions
General Disclaimer
• The information in this quick installation guide is subject to change due to product updates
or other reasons. This guide cannot replace the product labels or the safety precautions in
the user manual unless otherwise specified. All descriptions here are for guidance only.
• Before installations, read through the quick installation guide. For additional information,
please see the user manual.
• All operations should be performed by trained and knowledgeable technicians who are
familiar with local standards and safety regulations.
• Check the deliverables for correct model, complete contents, and intact appearance. Contact
the manufacturer if any damage is found or any component is missing.
• Use insulating tools and wear personal protective equipment when operating the equipment
to ensure personal safety. Wear anti-static gloves, clothes, and wrist strip when touching
electronic components to protect the equipment from damage. The manufacturer shall not
be liable for any damage caused by static electricity.
• Strictly follow the installation, operation, and configuration instructions in this guide and user
manual. The manufacturer shall not be liable for equipment damage or personal injury if you
do not follow the instructions. For more warranty details, please visit
warranty.
Safety Disclaimer
WARNING
• Do not touch the equipment in case of short-circuit. Power off the equipment immediately.
• Before wiring, disconnect all upstream switches to ensure the equipment is not powered on.
• Before operation, make sure the equipment is reliably grounded.
• Use appropriate tools for proper installation, maintenance, etc.
• Observe local standards and safety regulations when operating the equipment.
• Unauthorized dismantling or modification may damage the equipment, the damage is not
covered under the warranty.
• All labels and warning marks must be clear and distinct after the installation. Do not block,
alter, or damage any label.
• Warning labels on the equipment are as follows:
High voltage hazard. Power
off the equipment before any
operations.
Read through the user manual
before any operations.
CE marking
Potential risks exist. Wear
proper PPE before any
operations.
Grounding point. Indicates the
position for connecting the PE
cable.
Do not dispose of the product
as household waste. Discard
the product in compliance with
local laws and regulations,
or send it back to the
manufacturer.
01
https://en.goodwe.com/
EN