Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP
1.
Teaching of the trigger (depending on the year of your screen and
in the course of developments, the control board of your projecti-
on screen, the teaching process of your trigger may have changed):
Variant 1:
1.
Disconnect the screen from the power supply and reconnect it after
10 seconds.
2.
Within 5-8 seconds, press the programming button on the trigger.
3.
The screen moves up and down briefly, the trigger is programmed.
Variant 2:
1.
Disconnect the screen from the power supply and reconnect it after
10 seconds.
2.
Press the small button on the back of the radio remote control under
the battery cover twice, it beeps with each press
3.
Within 5-8 seconds, press the programming button on the trigger, it
beeps and the trigger is connected.
Variant 3:
1.
Disconnect the screen from the power supply and reconnect it after
10 sec.
2.
Press the small button on the back of the radio remote control under
the battery cover 5 times, it beeps with each press.
3.
Within 5-8 seconds, press the programming button on the trigger. It
beeps and the trigger is connected.
2. Now plug the transmitter into the projector. Please make sure that the pro-
jector is in standby mode. If your projector does not have a 3.5mm 12V trigger
socket, please use the USB adapter and connect the trigger to a USB socket.
3. As soon as the projector is switched on, the transmitter triggers the screen
and the screen extends. As soon as the projector is switched off, the transmit-
ter triggers the screen and the screen retracts. Please note that depending on
the projector and the mode set, the trigger function is only activated at the
end of the projector's switch-off process.
Please note: There are devices which do not
power the trigger or USB outputs in standby
mode sufficiently, the trigger function may
not work with the projection screen.
programming button transmitter
3
Publicidad
