Publicidad
CAUTION
Please read the following rules for safe operation and instructions carefully.
WARNING
1. Keep electrical appliances out of reach from children or infirm persons. Do not
let them use the appliances without supervision.
2. Ensure that the fan is switched off from the supply mains before removing the
guard.
3. If the supply cord is damaged, it must be replaced by manufacturer or its
service agent or a similary qualified person in order to avoid a hazard.
ASSEMBLY OF BLADE OF GRILLES
1. Unscrew the spinner clockwise and the nut counter-clockwise then remove
both of them.
2. Set the rear grille in the proper position with handle up.
3. Screw on plastic nut tightly to attach rear guard.
4. Discard plastic sleeve on motor shaft.
5. Install the blade onto the motor shaft until it reaches the retaining pin.
6. Screw spinner on to motor shaft counter clockwise.
7. Unscrew the locking screw mounted on the rear grille. Mount front grille onto
rear grille with the small round holes on the top matched for the passage of
locking screw. Fix both grilles with cclips and the use screwdiver to tighten
the locking screw.
ASSEMBLY OF BASE
1. Detach screw from base of the fan.
2. Match locking lug to base.
3. Tighten the screw from the base to lock the fan and base.
OPERATING INSTRUCTIONS
1.
To make/stop the fan head oscillate, push down/pull the clutch knob.
2.
To adjust the airflow upward or mild downward, simply loosen the
Swivel Adjustment Knob and move to desired angle then firmly tighten
the Swivel Adjustment Knob.
3.
Speed is controlled by depressing the keys.
4.
Plug the power supply cord into a wall outlet.
CLEANING
1.
Be sure to unplug from the electrical supply source before cleaning.
2.
Plastic parts should be cleaned with mild soap and a damp cloth or
sponge.
3.
Be sure not to make water or other liquid enter inside of motor.
OPERATING INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
TABLE FAN
Publicidad
