Publicidad
Idiomas disponibles
Idiomas disponibles
C
Cleaning and maintenance
Cleaning and maintenance
• Always unplug the unit from the mains power socket and allow
it to cool down for approximately 30 minutes before cleaning it.
• Drain the remaining water in the water tank to prevent it from
leaking during cleaning.
• Do not use solvents or abrasive products to clean the iron. Wipe
the iron with a soft, damp cloth and dry it thoroughly.
• To remove any build-up of calcium and limscale around the
steam holes, use a cotton wool tip dampened with methylated
spirits. Wipe off the methylated spirits with a soft, damp cloth
and dry it thoroughly.
• Regularly clean your unit and keep it dust free to reduce the
need for repairs and ensure product longevity.
• Clean the unit with a slightly damp, soft cloth. Make sure that
no liquid enters the inside of the unit.
• When cleaning the unit, never use abrasive detergents, metal
brushes, scouring or metal foams, or sharp utensils.
• Never immerse the unit, cable or plug in water or any other
liquid.
Cleaning the anti-calc filter
The anti-calc filter should be cleaned every 2 to 4 weeks, depending
upon the frequency of use and the hardness of water in your area.
1.
Remove the water tank by the tank handle and then pulling
it out.
2.
Pull open the water tank cover.
3.
Use a Phillips screwdriver to unscrew the anti-calc filter.
4.
Disconnect the filter from the tube.
5. Soak the anti-calc filter in white vinegar for a minimum of 4
hours.
6. After the filter has been soaked for at least 4 hours, rinse it
with tap water and then fit it back into the water tank.
23
EN
Publicidad
