Eldom Ideal IZ8901 Manual De Instrucciones página 9

EN
INSTRUCTION MANUAL
SONIC TOOTHBRUSH IZ8901
GENERAL INFORMATION
1. Spindle
2. Housing
3. Power switch
4. Operating mode indicator
5. Empty battery indicator
6. Socket
7. Replaceable head
8. USB cable
9. Case
INTENDED USE
The IZ8901 toothbrush has been designed to use sonic technology. During operation, the
toothbrush head vibrates at speeds ranging from 31,000 to as many as 40,000 beats per minute,
dynamically cleaning teeth and inter-dental spaces. This makes it possible to remove impurities
from hard-to-reach areas more accurately.
CHARGING THE DEVICE
The device may only be used after it has been charged.
Turn off the device before charging.
• When the battery level is low, the charging indicator will flash 10 times to remind you to charge.
• Connect one end of the cable (8) to the socket (6) and the other end to the power adapter (not
included) with the parameters listed above, and then to the mains.
• During charging, the light (5) will be on, and after charging, it will turn off.
• The device cannot be used during charging.
• When using the device for the first time or when it is not used for a long time, it is normal for
the indicator (5) not to light up for the first few minutes.
REPLACING THE HEAD (7)
The brush head (7) is a working part and should be replaced every 3 months for hygienic reasons
and whenever its bristles are worn. It is not subject to warranty repair.
The brush head (7) can only be replaced by the original brush head type included in the IZK8901
range.
• The head can only be replaced when the toothbrush is switched off.
• Replacing the head (7) while the toothbrush is running may cause damage to the spindle (1).
• Attach the head (7) as shown in Fig. 1.
• Keep a small gap between the housing (2) and the head (7) to allow proper device operation
Fig. 1.
If there is no gap, the device will be damaged when turned on.
OPERATING MODE SELECTION
• To select the operating mode, press the button (3) until the correct light (4) comes on.
• If the button (3) is not pressed within 3 seconds, pressing the button (3) again will switch
off the product.
• The toothbrush will always begin working in the last mode selected.
Mode
White
Clean
Sensitive
Polish
Massage
USE
• Put the tip (7) on the stem (1) - Fig. 1.
• Wet the bristles on the tip (7).
Method of operation
For the elimination of stains.
Daily plaque removal
For cleaning sensitive teeth and gums
For polishing teeth and brightening
Front teeth.
For massaging the gums
TECHNICAL DATA
Speed: 31,000 - 40,000 bpm
Battery: DC 3.7V, 260mAh, Li-Ion
Charging time: 4 hours
Operating time: up to 30 days
(2 minutes twice/day)
Toothbrush water-tightness: IPX7
Material
- housing: ABS/TPE
- head bristles: Dupont Nylon
Charging method: cable
Connect the cable (8) to a power supply unit
with the following parameters:
DC 5V, 1A (not included)
Two minutes, impulse every 30
seconds
Operating time
9