Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Step 5: INSTALLATION
This hood is intended to be mounted onto
the kitchen wall.
1. Remove the grease filter (refer to Opera-
ting Instructions).
2. Draw a line on the wall from the ceiling to
the lower edge of the hood at the center
of the location where the hood is going
to be mounted.
3. Use the template to mark the points on
the wall where the screws will be moun-
ted. In order to make it easier to hook
the hood onto the screws, draw the out-
line of the area where the hood will be
attached.
rN
CAUTION — Ensure that the minimum
distance between the cooktop and the
hood is maintained — 30". The bottom edge
of the template equates to the lower edge
of the hood.
4. Drill 2x 17." @ holes for the upper fixing
bracket and
2x V/s" @ holes for the lower fixing bracket
and press in wall plugs flush with the
wall.
Note: At least one screw for the mounting
must be installed through a stud.
Note: Take into account any special
accessories that are going to be fitted.
5. Attach the 2 enclosed spacers to the
fixing bracket for the flue duct panelling.
Attach the fixing bracket for the
chimney panelling using two hexagon
head cap screws.
6. Attach the hood.
Adjust the height and align horizontally
with the adjusting screws.
Publicidad
