Grip Rite GRTCS250 Manual Del Operador página 11

ADJUSTING NAIL DRIVE
1. Disconnect tool from air supply
using quick-connect coupling.
2. Turn adjustment dial backward
to increase nail drive, or forward
to decrease nail drive, as
shown by nail symbols on tool.
3. Connect tool to air supply, and
drive nails to check for correct
depth of drive.
4. Make depth of drive adjustments
as needed to maintain
consistent nail driving.
CLEARING NAIL JAMS
1. Disconnect tool from air supply
using quick-connect coupling.
2. Open door, remove nails from
drive channel and feed pawl.
3. Insert rod into nose bore, and
push nail back through drive
channel and out of guide body.
If necessary, tap rod lightly with
a hammer to free jammed nail.
4. Remove nail from drive channel
using pliers.
SELECTING TRIGGER
OPERATION
1. Disconnect tool from air supply
using quick-connect coupling.
2a. BUMP FIRE OPERATION
Slide the selector button (E) on the
trigger to the forward position.
2b. SEQUENTIAL FIRE OPERATION
Slide the selector button (E) on the
trigger to the rear position.
3. Connect air tool to air supply at
quick-connect coupling.
11
OPERATION