Grip Rite GRTFR83 Manual Del Operador página 10

OPERATION
LOADING FASTENERS
A fastener can be driven unintentionally if the trigger and safety
bracket are activated at the same time. Always disconnect tool
from air supply before loading fasteners, making adjustments, or
performing any service on tool. Keep finger off trigger until ready
to drive a fastener.
LOADING INSTRUCTIONS
1. Hold tool handgrip securely.
2a. TOP LOADING
Insert nail strip into TOP of
magazine, with nail points
angled forward and down.
Slide nail strip forward.
2b. REAR LOADING
Insert nail strip into REAR of
magazine, with nail points
angled forward and down.
Slide nail strip forward past
stopper (C).
3. Pull pusher (A) back to rear of
magazine, behind last nail strip.
4. Slide pusher forward to engage
last nail strip, and release.
5. Tool is now loaded and ready
for normal operation.
UNLOADING NAILS
1. Pull pusher back, fully depress
pusher lever (B), then slide pusher
all the way forward to front
of magazine.
2. Release pusher lever (B).
3. Slide nail strips back to rear of
magazine, and remove the
nails from magazine.
DANGER
10