Contest VCOB-60DW Manual Del Usuario página 25

English
7 - Setting setting
VCOB-60DW and VCOB-120DW projectors are configured using the remote RDM control box VRDM-CONTROL. This box makes it possible to deport the
control part of the projector in order to make all the adjustments (settings) of the projector via the DMX cord by RDM protocol.
The menu is different depending on the type of projector, the functions are as follows:
VRDM-CONTROL
MENU
RDM Products List
Page 10
VCOB-DW - Dynamic white COB LED architectural projectors IP66
Label: ''Product Name''
Model: ''Product Name''
Manufacturer: Hitmusic SAS
Firmware: V1.00
DMX Address: 001 (XXX)
DMX Personality: CH list
DMX Slots:
ON (By default)
Identify:
OFF
Temperature: ...
NO DMX
Slave mode
Stand-Alone Mode
Fixture Menu
Setting Mode
The name of the product connected to the box
The name of the product connected to the box
The name of the manufacturer
Firmware version
DMX address 001 start (XXX) end
Number of used channels
Allows you to flash the selected projector in order to
identify it among the other projectors
Internal temperature of the projector
Blackout
Freeze (By default)
Stand-Alone
Single
Master
Slave (By default)
Master Dimmer
Flash
CCT adjust
CCT presets
Dimmer curves
White Balance
PWM Frequency
Temperature
Time info
DFSET
Values from 000 to 255
Values from 000 to 255
Values from 000 to 255
Presets list
Linear
Exponential (By default)
Logarithmic
S-Curve
WW
CW
900Hz
1200Hz (By default)
2400Hz
3600Hz
°C (By default)
°F
...
OFF
ON