MSW -AIRP35PN Manual De Instrucciones página 12

aa) Attention! A fastening element may jam in the device's outlet. Remember to disconnect the device
from source of compressed air before removing the jam. Otherwise, a user may suffer serious injuries!
bb) Lubricate the compressed air intake daily.
ATTENTION! Despite the safe design of the device and its protective features, and despite the use
of additional elements protecting the operator, there is still a slight risk of accident or injury when
using the device. Stay alert and use common sense when using the device.
3. Use guidelines
The machine is designed for the installation of nails for floorboards, cabinet construction, panels, pallets and
packaging, etc.
The user is liable for any damage resulting from unintended use of the device.
3.1. Preparing for use
APPLIANCE LOCATION
The ambient temperature must not exceed 45°C and the relative humidity should not exceed 85%. Only
use the device in well-ventilated areas. Do not obstruct the air outlet of the device. Keep the device away
from any hot surfaces. The device should always be used when positioned on an even, stable, clean,
fireproof and dry surface, and be out of the reach of children and persons with limited mental and sensory
functions. The valve that disables the compressed air supply should be immediately accessible from the
area where the device is being used. Make sure that the pressure of the air supplying the device does not
exceed the recommended range.
3.2. Device use
The device is driven by compressed air - the supply connection of the device should be equipped with an
air preparation kit, i.e. a dryer, an oiler (lubricator) and a pressure regulator.
Before connecting the device to the compressed air system, it should be depressurized. If you do not have
a lubricator in your compressed air system, you should drip 2 drops of pneumatic equipment oil through
the air inlet before each use of the device.
To load the magazine with nails, release the magazine by pressing the release trigger.
EN