Zipper Maschinen ZI-HAEK4000 Manual De Instrucciones página 25

13 OPERATION
Machine to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating the
device.
13.1 Operation instructions
 Do not stand in the discharge chute area during starting the machine
 Before starting check that the in-feed the free from any material
 Start shredding after the engine has reached full speed
 Operating only with sharp blades
 Use only blades allowable for this machine!
 Never use damaged blades!
 Always operate in the operator zone
 Never stay in the in-feed zone
13.2 Operation
13.2.1 Start, stop
Set the ON-OFF switch to „ON"(I).

ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-HAEK4000
Stop the machine before any break, maintenance and cleaning!
The machine is delivered without any gasoline or oil.
WARNING
RISK OF INJURY!
NOTICE
WARNUNG
25