INSTRUCTIONS FOR USE
BEFORE USE:
Make sure that all the product's
•
packaging has been removed.
Prepare the appliance according
•
to the function you wish to use.
SETTING DATE, TIME, UNIT OF
PRESSURE AND MEMORY:
When the monitor is off, press
•
button SET (4) for about 3 se-
conds. The year digit will begin to
flash. Press the memory button
(3) to select the corresponding
year.
Next, press button (4) again and
•
change the month using the me-
mory button (3).
Now press button (4) to change
•
the day by using the memory bu-
tton (3).
Next press button (4) to change
•
the hour by pressing the memory
button (3).
Now press button (4) to change
•
the minutes by pressing the me-
mory button (3).
Next press button (4) to change
•
the unit of pressure (15) by pres-
sing the memory button (3).
After the unit is set, the LCD will
•
display "donE" first, then display
all the settings you have done
and finally it will turn off.
To change from memory 1 ( ) to
•
2 ( ), with the machine off press
the SET button (4) until one of
the two memories appears (14),
once selected press the Start/
Stop button (2) again and it will
switch off.
USE:
Unroll the cuff and flexible tube
•
completely.
Connect the flexible tube to the
•
flexible tube connector.
Insert the end of the cuff through
•
the metal hasp leaving the Velcro
facing outward.
Uncover the left arm and insert
•
the arm inside the cuff so that
the outlet for the flexible tube
is aligned with the centre of the
arm, using the middle finger as a
reference (Fig. 2).
Place your arm on the table with
•
your palm facing upward.
Fit the cuff to the top of the arm,
•
leaving a distance of approxima-
tely 2-3 cm between the cuff and
the elbow.
Smooth out the cuff to ensure
•
there is no air between the arm
and the band, and adjust it using
the Velcro fastener. Do not over
tighten. Approximate one finger
should be able to fit underneath
the cuff after tightening.
Measurements must always be
•
taken on a bare arm or in rolled
sleeves but without exerting any
pressure on the arm.
EN