Johnson GreenBrite JLD300-GN2D Manual De Instrucciones página 14

Láser de líneas cruzadas y 2 puntos

Ocultar thumbs Ver también para GreenBrite JLD300-GN2D:

Idiomas disponibles

3. Using the Unit in Automatic Mode

IMPORTANT: If the unit's position changes after it has self-leveled,

verify the unit's position (for example, height) to the potentially

changed conditions.

Slide the locking compensator/power

switch to the left to the unlocked

(ON)

position to power on the

unit. The level indicator and power

indicator will light up. (Figure 14)

Power/Battery LED:

2. On the keypad, press the

laser beam. Press the

beam. Press the

unit can be used with any combination of laser beams turned on

simultaneously. Disabling a laser you are not using extends the

life of the battery.

NOTE: The unit must be within ±4° of level for the self-leveling

feature to function properly. If the unit is beyond its 4° self-leveling

range, the laser will not self-level, the laser will flash, and the level

indicator status light will flash red. Once the unit has been adjusted

to within its 4° self-leveling range, the laser will self-level, the status

light will turn green, and the laser light will stop flashing and remain

solid.

Steady green LED indicates power is on

and battery power is greater than 30%.

Steady red LED indicates power is on and

battery power is between 30% and 15%.

Flashing red LED indicates power is on

and less than 10%. Charge or change the

batteries.

Extinguished LED indicates power is off or

battery has been depleted.

button to turn on the horizontal

button to turn on the vertical laser

button to turn on the dot laser beam. The

Figure 14