Johnson GreenBrite JLN300-GNCL Manual De Instrucciones página 6

How to Install or Replace Batteries
NOTE:
• Always check that the locking compensator/power switch is in the
locked position before removing and replacing batteries.
• Use only alkaline batteries or Lithium-ion battery pack.
• Remove the batteries when storing the tool for an extended time
(more than 3 months) to avoid damage to the unit should the
batteries deteriorate.
1. Rotate the Cross-Line laser so the rear
of the unit is accessible. (Figure 3)
2. Push down on the battery door lock
tab to unlock the battery door. Allow
the battery compartment door to fall
open. (Figure 4)
6
Figure 3
Figure 4
©2023 Johnson Level & Tool