Publicidad
2. Start the pairing operation for Bluetooth
technology on the device.
3. If it is necessary, select Husqvarna X-COM Active in
the list of units on your device.
Note:
An audio message tells you about the
product status. Refer to the table below.
Audio message
LED indicator on
the Bluetooth
button
BLUETOOTH
Solid blue.
DEVICE CON-
NECTED
BLUETOOTH
Solid red for 2
CONNECTION
seconds.
FAILED
Note:
A device with Bluetooth
that is connected to your product, connects
automatically to your product the next time the product is
used with the device.
To change audio streaming
•
Push and hold the volume up button for 0.5 seconds
to select the next audio streaming.
•
Push and hold the volume down button for 0.5
seconds to go back to the previous audio streaming.
To stop or start the audio streaming
•
Push the mode button to stop or start the audio
streaming.
To accept, end or dismiss a phone call
If your mobile device is connected to the product with
®
Bluetooth
wireless technology, a signal is heard in the
earmuffs when there is an incoming phone call.
•
Push the mode button to accept or end the phone
call.
To do maintenance on the product
CAUTION:
product fully into water.
10
®
wireless
Information
®
The product is
connected to a
device with Blue-
®
tooth
wireless
technology.
The product is
not connected to
a device with
®
Bluetooth
wire-
less technology.
®
wireless technology
Maintenance
Do not flush or put the
•
Push the mode button for 1 second to dismiss an
incoming phone call.
Note:
A beep sound tells you when the phone call
is accepted or dismissed.
Audio message
CALL ENDED
To adjust the volume
•
Push the volume up button or volume down button to
adjust the volume. A beep sound tells you when the
volume is at the minimum or maximum level.
To set to ambient sound mode
Ambient sound mode lets you hear the sounds around
you.
•
Push the ambient sound button.
Note:
An audio message tells you the status of the
ambient sound mode.
Audio message
AMBIENT LEVEL HIGH
AMBIENT LEVEL MEDIUM
AMBIENT LEVEL LOW
AMBIENT LEVEL OFF
To stop the product
•
Push and hold the on/off button for 1 second.
Note:
An audio message tells you the battery
status and the LED indicators go out. A beep sound
tells you that the product is off.
To stop the product by force
•
Push and hold the on/off button for 12 seconds.
CAUTION:
cleaning agents that contain solvents and/or
alcohol can decrease the protective function.
CAUTION:
spare parts.
Information
The phone call has
ended.
Spray, liquids or other
Use Husqvarna original
2146 - 004 - 18.12.2023
Publicidad
