Monkey loop ML-TU1 Manual Del Usuario página 2

ML-TU1
MONKEY LOOP
OPERATION AND FUNCTION
1. ON / OFF Button
2. Pitch Button
3. Flat Button
4. Screen: a.Note Name b.Tuning Meter and Calibration
c. Pitch d. Flats
5.Input
6.Output
7.9V DC Power In
HOW TO USE
1. Connect a DC 9V power into the pedal. Please pay much attention to
the power polarity.
2. Turn on the tuner by pressing on ON/OFF button.
3. If you want to change the pitch, then press A4 button. The pitch
ranges from 430Hz to 450Hz.
4. If you wish to tune by note flat, press Flat button. Flats offer 4 steps:
5. Play a single note from your guitar, the note name will appear in the
tuner screen.The screen color will change, and the tuning needle will
move.
- The center blue tuning meter appears, and 2 blue triangles appear:
note in tune.
- The left red tuning meters appear, and the left blue triangle appears:
flat note
- The right yellow tuning meters appear, and the right blue triangle
appears: sharp note.
6. The tuner has bypass function. When tuning finished, press ON/OFF
button, the original guitar signal will get through without any distortion.