Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
C-ACC-EB-8W-KIT-UL Series
6. Install the EM driver and battery onto back box by tightening (4)
supplied screws through holes in mounting bracket and into bosses
in back box. See Figure 5.
7. Plug test switch 4-pin connector into 4-pin port on emergency
driver. See Figure 6.
8. Plug emergency battery 2-pin connector into 2-pin port on
emergency driver. See Figure 7.
9. Make wiring connection to the fixture per the Electrical Connections
section.
NOTE: Make sure these wiring instructions are followed for
emergency equipped products. Do NOT follow wiring instructions
included with the fixture.
10. Replace the lens assembly on the hinges of the back box.
11. Connect the 2-pin male connector from the LED driver to the 2-pin
female connector from the CCT/wattage adjustment switches on the
lens assembly. See Figure 8.
12. Connect the female connector from the emergency driver with the
male connector from the CCT/wattage adjustment switches on the
lens assembly. See Figure 9.
13. Connect the male connector from the emergency driver with the
female connector from the LED driver. See Figure 10.
14. Swing lens into place. Re-tighten screws that were loosened in
Step 1.
FIGURE 5
FIGURE 6
Screw Locations
EM Driver
EM Battery
4-pin Connector from
Test Switch Plugged into
4-pin Port on Emergency
Driver
http://lighting.cree.com/warranty
Document:
LPN05498X0001A0_B
Created By:
TMT
FIGURE 7
FIGURE 8
CCT/Wattage
Adjustment
Switches
FIGURE 9
CCT/Wattage
Adjustment
Switches
FIGURE 10
|
1-800-236-6800
Date
3-6-2023
2-pin Connector from
Emergency Battery
Plugged into 2-pin Port
on Emergency Driver
LED Driver
EM Driver
LED Driver
EM Driver
Publicidad
