Create BARBER V800 Manual Del Usuario página 12

Always disconnect the mains adapter from the socket and the small plug of the mains adapt-
er cable from the mains adapter port of the hair clippers before cleaning. Switch the hair
clippers off.
WARNING: Never immerse the hair clippers in water or any other liquid.
• Take off the comb attachment if one is installed. The comb attachment can be cleaned
using soapy water. Then dry it well.
• The casing of the hair clippers can be wiped using a slightly damp cloth; never use any
aggressive cleaning agents.
• Remove any remaining hair from the cutter block and the hair reservoir using the cleaning
brush.
• For more intensive cleaning, you can remove the cutter block from the hair clippers. Use
your thumb to press on the metal blade from the front until the cutter block is released
from the head of the hair clippers. Remove the cutter block.
• Remove any remaining hair from the head of the hair clippers and the removed cutter block
using the cleaning brush. Then the cutter block can be rinsed under running water. Dry the
cutter block thoroughly after cleaning. Work carefully to avoid damaging the cutter block.
• To ensure free movement of the cutter block, it must be oiled after cleaning. To do so, apply
a few drops of blade oil to the blades of the cutter block.
• Now reinstall the cutter block into the head of the hair clippers:
1. Set the cutter block onto the head of the hair clippers from above so that the guide lug of
the cutter block engages in the groove on the head.
2. Push the cutter block into the head until it engages audibly and fits securely.
E NGL I SH
12
CLEA NI NG A N D M A I N T E N A N C E