Nolan N100-6 Seguridad E Instrucciones página 21

REMOVABLE INNER COMFORT PADDING
The comfort padding consists of:
- liner
- side cheek pads (right and left)
All components can be completely removed and washed.
The cheek pads are also characterised by removable inner expanding foam padding.
Deactivate the VPS and lift the helmet chin guard to remove and/or install the comfort
padding (see instructions above).
1 DISASSEMBLING THE CHEEK PADS
1.1 Open the chin strap (see specific instructions) and remove the chin strap band
from the elastic loop on the cheek pad strap (Fig.15).
1.2 Pull the front of the left cheek pad towards the inside of the helmet to release the
three buttons on its back (Fig. 16).
1.3 Remove the rear tab of the comfort padding of the left cheek pad from the cavity
between the rear trim and the polystyrene inner shell; then completely remove the
cheek pad padding from the helmet (Fig.17).
1.4 Follow these operations with the right cheek pad padding.
Do not remove the polystyrene cheek pads from the helmet shell.
2 DISASSEMBLING THE INNER EXPANDING FOAM PADDING OF THE CHEEK PADS
To facilitate the washing of the inner comfort padding components, the cheek pads of
the helmet are equipped with inner expanding foam padding that can be removed from
the fabric lining. To remove the padding, proceed as follows after disassembling the
cheek pads from the helmet (see instructions above).
2.1 Unhook both eyelets "A" of the rear frame of left cheek pad slot next to the two
snap buttons (front and rear) located on the back (Fig.18).
2.2 Slightly remove the inner expanding foam padding from the fabric lining of the left
cheek pad (Fig.19).
2.3 Follow these operations with the right cheek pad padding.
Warning: once the inner paddings made of expanding foam have been removed
from the cheek pads, ensure that rear "B", front "A" and top "A" snap buttons are
correctly hooked to the rear frame of the fabric lining of the cheek pads (Fig.20).
Otherwise, position them again appropriately.
3 DISASSEMBLING THE LINER
3.1 Pull the front part of the comfort padding inwards with respect to the helmet, up to
release left and right rear tabs on the liner from the rear edge of the shell (Fig.21).
3.2 Hold the left front part of the liner and pull it upwards in order to remove the cor-
responding liner tab from the support fixed to the polystyrene inner shell (Fig.22).
Then repeat the steps with central front and right tabs as well.
3.3 Completely remove the comfort padding from the helmet.
INSTRUCTIONS FOR USE
N100-6
21