Publicidad
Idiomas disponibles
Idiomas disponibles
Remote control
1
2
3
8
5
7
10
12
Button
Press this button to turn on or off the speaker.
1. On/off/standby button
Press this button to toggle through the different audio sources available:
2. Mode selector
, USB, microSD™, Aux/Line In, FM. As there is no default mode assigned,
®
Bluetooth
the system starts automatically playing the last media source inserted.
• Alternates between the 8 preset LED features.
3. LED light selector
• Press/hold for 3 seconds and release the LED button to turn off the LED.
Mutes the audio coming from the speaker. Press it again to unmute the speaker
4. Mute
in all modes.
In USB, microSD™ and Bluetooth
5. Previous track
previous track. In FM mode press it briefly to go to the previous channel.
In USB, microSD™ and Bluetooth
6. Next track
track. In FM mode press it briefly to go to the next channel.
It decreases the volume level of the speaker. Volume can also be controlled
7.Volume down
directly from each of the sources connected to the speaker.
It increases the volume level of the speaker. The volume can also be controlled
8. Volume up
directly from each of the sources connected to the speaker.
Press to start and pause media during Bluetooth
9. Play/pause track
Use this button to repeat the current track or song only in USB and microSD™ modes.
10. Repeat track
It has a single repeat or repeat all functions.
11.Equalizer
Scrolls through the six (6) equalizer sound effects: CLA (classical), POP (pop), ROC
(rock), JAZ (jazz), COU (country) and NOR (normal)
In USB and microSD™ modes, press any of these keys to directly choose the tracks you
12. Number panel
want to play. In tuner mode, it allows the manual input of stations.
MODE
4
LED
MUTE
VOL+
9
6
VOL-
11
REPE
EQ
1
2
3
4
5
6
7
8
9
0
Function
mode press this button briefly to play the
®
mode press this button briefly to play the next
®
, microSD™ or USB playback.
®
IV. Initial setup
Note: For your safety, read this manual and follow all safety instructions before using the product.
Charging the battery
1. Plug the supplied power adapter on the speaker and connect the other side to the wall outlet.
2. The LED charging indicator (on the top panel) will turn red while charging and blue when fully charged.
3. When the unit is not in use or switched off, it will automatically recharge the internal battery as long as
it remains connected to utility power.
4. When the battery is reaching a low voltage level (or discharges), the volume of the speaker output will
be reduced, and a warning tone will follow. At this time the speaker needs to be charged. Otherwise, it
will shut off.
Powering on the unit
1. Turn the volume control on the top panel fully counterclockwise.
2. Connect audio input devices first. Make sure all input sources such as microphones, CD players, or digital
media players are turned off and volume settings are set to their lowest settings (zero).
3. Then, connect the power adapter to the loudspeaker and AC power outlet. Turn ON the speaker using
the on/off switch on the top panel.
4. Slowly turn the volume clockwise until the sound output is at the desired level. If there is no sound, check
to make sure the source equipment is providing audio output.
V. Operating modes
1. Auxiliary playback
Recommendation: A 3.5mm to 3.5mm connector audio cable has to be used to enable audio playback from
devices fitted with an auxiliary 3.5mm jack.
a. First, connect one side of the 3.5mm cable to the auxiliary port on the speaker and the other side of
the cable to the source of choice. If the speaker is not set to the Aux/Line mode, press the MODE
button to toggle through the different modes available until the preferred mode is found — Aux/Line,
, USB, microSD™, FM.
Bluetooth
®
b. Start streaming audio files directly from the source of choice.
2. USB mode operation with the remote control
Recommendation: Use a USB memory stick to enable audio playback from compatible files stored in a USB
memory stick.
a. First, connect a USB memory stick to the USB port of the speaker.
b. The speaker will detect the USB device and play the audio files. If the USB drive is not automatically
detected, press the MODE button to toggle through the different modes available until the preferred
mode is found — Line In, Bluetooth
, USB, microSD™, FM.
®
c. Start streaming audio files directly from the source of choice.
d. Press the
button to play or pause the audio.
e. Press the
/
button shortly to go to the previous or next track.
Publicidad
