Publicidad
Idiomas disponibles
Idiomas disponibles
TO ADJUST
HANDLE
The handle on your lawn mower has
three (3) height positions - adjust to
height that suits you.
• Squeeze
the bottom ends of lower
handle towards each other until the pin
in handle can be inserted
into one of
the three height adjustment
holes.
Hi
Handle pin
Handle
TO ASSEMBLE
GRASS
CATCHER
1. Put grass catcher frame into grass bag
with rigid part of bag on the bottom.
Make sure the frame handle is outside
of the bag top.
2. Slip vinyl bindings over frame.
NOTE:
If vinyl bindings are too stiff, hold
them in warm water for a few minutes. If
bag gets wet, let it dry before using.
ACAUTION:
Do not run your lawn
mower without clipping deflector or
approved grass catcher in place. Never
attempt to operate the lawn mower with
the rear door removed or propped open.
Catcher
frame
handle
Frame
opening
ENGINE
ENGINE
SPEED
Your engine speed has been factory set.
Do not attempt
to increase
engine speed
or it may result in personal
injury.
If you
believe
that engine is running too fast or
too slow, take your mower to a Sears or
other qualified
service
center for repair
and adjustment.
CARBURETOR
Your carburetor is not adjustable.
If your
engine does not operate properly due to
suspected
carburetor problems, take your
lawn mower to a Sears or other qualified
service center for repair and/or adjust-
ment.
IMPORTANT:
Never tamper with the
engine governor, which is factory set for
proper engine speed.
Overspeeding
the
engine above the factory high speed
setting can be dangerous.
If you think the
engine-governed
high speed needs
adjusting, contact a Sears or other
qualified service center, which has proper
equipment
and experience
to make any
necessary
adjustments.
14
Publicidad
