Würth VP 800 Traducción Del Manual De Instrucciones De Servicio Original página 10

The vacuum gauge 3 must show a vacuum of
■
above 600 mm/HG. If not check for leakage.
Do not commence work until the required vacuum
■
has been reached.
Watch the vacuum gauge 3 while working. If the
■
vacuum drops below 600 mm/HG, interrupt the
work immediately and completely remove the drill
stand.
Empty the fluid collecting container
If fluid is sucked in during operation, the vacuum
■
will no longer be maintained. Pull the mains plug
out immediately.
Unscrew the fluid collecting container 7.
■
Remove the float and empty the container.
■
Replace the float and screw on the container
■
tightly again.
CAUTION
The machine becomes hot after a long peri-
od of use. Do not touch the machine directly
after operating it.
Transport and storage
Clean the machine and remove the drilling dirt.
■
Blow out remaining water from hose and machine
■
when it freezes.
This appliance may only be stored inside a build-
■
ing.
Maintenance and care
Regular inspection and cleaning can prevent unneces-
sary damage and repairs.
Clean regularly the fluid collecting container and
■
the ball of the water-separator.
– Remove the dirt and clean with water.
– Check the rubber seals and if damaged,
replace them.
Test the pump on its vacuum capacity. The minimal
■
vacuum should 600 mm/HG.
Never lubricate this oil-less pump.
■
If – in spite of meticulous manufacturing and testing
processes – the device fails, have it serviced by a
Würth masterService®.
Please provide the item number given on the device's
nameplate whenever you have an enquiry or if you
want to order replacement parts.
10
This device's current replacement parts list can be
found on the Internet at http://www.wuerth.com/
partsmanager or requested from your nearest Würth
branch office.
Troubleshooting
For malfunctions that are not specified in this chapter,
when in doubt or when explicitly indicated, seek assis-
tance from an authorized service facility.
Warranty
For this Würth device we grant a warranty in accord-
ance with the statutory/country-specific provisions as
from date of purchase (by evidence of invoice or deliv-
ery note). Damage that has occurred will be corrected
either by replacement or by repair.
Damage caused by improper handling is excluded
from the warranty.
Claims can be recognized only if the device is pre-
sented in a not-disassembled manner to a Würth
branch office, your Würth field service employee or
a customer service office for power tools authorized
by Würth.
We reserve the right to make technical changes. We
accept no liability for printing errors.
Environmental Protection
Do not dispose of this device in household
waste. According to European Directive
2012/19/EU on waste electrical and elec-
tronic equipment and its implementation in
national law, broken and unserviceable
electric tools must be collected separately and submit-
ted to an environmentally sound recycling facility.
Ensure that your used device is returned to your dealer
or obtain information about a local authorised collec-
tion and disposal system. Ignoring this EU directive
can have potential effects on the environment and
your health!