Sony BRU-SF10 Manual De Instrucciones página 7

P AUDIO OUT L/R jacks
Loop through output of the audio line signal input
from the AUDIO IN jacks on the BRBK-SF1 HD
Optical Multiplex Card inserted into the camera via
the Optical Fiber Cable.
Q VISCA FUNCTION switches
These switches are used for the VISCA
communication settings.
Switch 1 (RS-232C/RS-422 selector)
Set to ON for RS-422, or OFF for RS-232C.
Switch 2 (Communication baud rate
selector)
Set to ON for 38400 bps, or OFF for 9600 bps.
Switches 3 to 5 (Camera address selectors)
Set the address of the camera.
Normally set to "0". With this setting, addresses are
assigned to the cameras automatically in the
connected order by pressing the POWER button
while holding down the RESET button on the
RM-BR300 Remote Control Unit (not supplied).
You can assign the camera address "1" to "7"
manually by setting these selectors as follows:
Camera 0 1
address
Switch 3 OFF ON OFF ON OFF ON OFF ON
Switch 4 OFF OFF ON ON OFF OFF ON ON
Switch 5 OFF OFF OFF OFF ON ON ON ON
Note
Cameras with addresses assigned by setting the
switches to "0" and cameras with addresses
assigned to "1" to "7" cannot be used together. In
addition, the same address cannot be assigned to
multiple cameras manually.
Switch 6 (59.94/50 signal format selector)
Set to ON for output of 50 signal format, or OFF for
output of 59.94 signal format.
The 1080i and 720p formats are automatically
applied to this unit based on the BOTTOM switch
setting of the camera.
Be sure to configure the same setting on this unit
and the camera.
Switches 7 to 10: Not used. Set them to OFF.
Note
Set the switches before you turn on the power of the
unit.
2 3 4 5 6 7
R DC 12 V connector
Connect to the supplied AC adapter.
S Card slot
Install BRBK-SA1 or BRBK-HSD2 optional
interface cards here.
The slot cover is attached to the unit at the factory.
Location and Function of Parts
7
GB