Hortensus Led ball OP 003888 Instrucciones página 8

Please read all instructions carefully before installation and use.
Specifications
Power consumption: 20CM/1.2W; 40CM/2.4W; 60CM/4.4W
Input: AC 100V-240V 50/60Hz
Output: DC 5V
Battery: 20CM/1000mAh; 40CM/2000mAh; 60CM/4000mAh
Charging time: 4-6 hours
Working time: 6-12 hours
IP Protection: Cube light IP44, ball light IP65
Instructions
Remove the orange charger seal to access the charging input. Charge for 6

hours for first use.
Please cover the DC input seal after charging to prevent water ingress.

Press the switch to turn on.

Press and hold the switch for a few seconds to turn off.

The indicator light on the charger is red when the lamp is charging and turns

green when the battery is fully charged.
Functions
Speed -
Brightness –
Speed+
Brightness+
Cautions
Do not use the lamp near heat sources.

Prior to use, check the device for visible external damage.

Never immerse the device in water or any other liquid.

The device is not a toy. Keep it out of the reach of children and pets.

Light jumps through RGB colors
Light strobes in white color
Light fades in and out through RGB colors
Light gradually cycles through RGB colors
6
EN