Pinnacle Climate Technologies MASTER MAC-20FOMNI Manual Del Usuario E Instrucciones De Operación página 4

1. Align Cradle Base (packed separately) with
support brackets attached to fan body sides.
Note: you may need to flex the parts to make
them align properly.
2. Insert support bracket into opening of Cradle
Base. Press spring loaded button down to allow it
to insert into Cradle Base, see Fig 1.
3. Press support bracket into Cradle Base until
spring button protrudes out open hole in Cradle
Base, see Fig. 2.
4. Repeat above process for opposite side of fan.
Note: There is one small hole on each side of the two
cradle bases. The two small holes should be kept
inner side and at the same directions.
5. Insert the plastic pads onto the two sides of the
axle, then the wheels and gaskets. Tighten the
nuts on the ends of the axle to secure the wheels
to the axle, see Fig. 10. Then simply align two
wheel clips to fan frame and push them to attach
as shown in Fig.11.
6. Slide the feet into the space holder as shown in
Fig. 12. Align the holes on the feet with the holes
on the frame and screw the screws in. Fig 13.
Fig. 10
© 2021, Pinnacle Climate Technologies, Inc.
NEVER LEAVE A FAN UNATTENDED WHILE OPERATING OR WHILE
MAC-24DCT / MAC-30BCT
Fig. 11
CONNECTED TO A POWER SOURCE
Fig. 12
Fig. 13
4
High Velocity Fan User's Manual