Publicidad
Idiomas disponibles
Idiomas disponibles
1. Pull out the release handle and turn it in the direction of the arrows,
then remove the battery holder (see Figure 3).
2. Place one or two NP-F570 batteries into the battery holder (see Figure
4).
3. Insert the battery holder into the grip (see Figure 5). After installation,
ensure that the holder is securely fastened to the grip.
4. Close the release handle (see Figure 5).
4. Specifications
• Power: NP-F570 (one or two )
• Compatible Models: Blackmagic 6K
• Operating Temperature: 0-40°C
• Weight : 367.7g ( Battery not included)
• Dimensions : 178.4 x 49.7 x 80.4 mm
5. Safety Precautions
Please follow these safety guidelines:
1. If you don't plan to use the camera for a long time, remove detach the
holding grip from the camera and remove the batteries.
2. Do not attempt to disassemble or repair the device on your own. Any
damage caused will not be covered by the warranty.
3. This device is not waterproof; avoid exposing it to water or humid
environments.
4. Keep the device away from fire or high-temperature environments.
5. Store the device and its accessories out of the reach of children to
prevent accidental ingestion.
6. If you need to replace the battery during use, first turn off the camera's
ON/OFF switch and then change the batteries.
Warning
• When disposing the battery, seal the lithium battery contacts with tape to
prevent short circuits, and follow local regulations for battery handling
• Stop using the device immediately and remove the battery if:
1. The product is exposed internally due to falling or collision.
2. The product emits an unusual smell, heat, or smoke.
• Do not attempt to disassemble it, as touching high-voltage currents
inside may result in electric shock.
6
Publicidad
