Publicidad
Idiomas disponibles
Idiomas disponibles
START AND STOP TIMER
Program start timer with trolley stopped, use + and - keys to set time, or leave
time to zero if you wish to have the machine start immediately.
If you wish the outlet valve or closing valve (option) to trip with a certain delay
at cycle end, use + and - keys to set wished time, or leave time to zero if you
wish to have the valve trip immediately at work end.
DELAYED START
Use + and - keys to enable or disable machine start at set time.
When activated, an X should be displayed in the suitable box,
it can be disabled with – key.
PAGE: STOP STATUS
In this position, if all operations have been performed correctly, press START
to start the work cycle.
PAGE: WINDING STATUS
Once START has been pressed, the work cycle starts and cycle end day and
time, hose winding speed, metres (ft) of unwound hose and machine flow rate
in l/min (G.P.M.) are displayed.
PROGRAMME "E" - ZONE RAIN
This programme allows you to program up to 4 zones and set different rain mm. (inch), for the same hose section.
Zone E1, set for how many mt. (ft) you want to deposit a certain quantity of water in mm. (inch).
Use + and - keys to set value, press PROG to confirm set value and go to next zone E2.
Set it in the same way.
Note: When using the zone priority, to set only 2 zones for instance, simply do not program zone 3 and the computer will
automatically not show zone 4.
It is important that total metres set in the various zones correspond to total metres unwound from machine and dis-
played by the computer.
EN
35
Publicidad
