Publicidad
Idiomas disponibles
Idiomas disponibles
Technical specifications
Model No
Charger input
Charger output
Charging time 2Ah battery
Charging time 4Ah battery
Recommended batteries
Weight
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2.
1. Battery unlock button
2. Battery LED indicators button
3. Battery LED indicators
4. Battery (not included)
5. Charger
6. Charger LED indicators
3. OPERATION
Before any work on the power tool,
remove the battery.
The battery must be charged before first
use.
Inserting the battery into the machine (Fig. B)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (4) into the base of the
machine as shown in Fig. B.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig. B)
1. Push the battery unlock button (1).
2. Pull the battery out of the machine like shown
in Fig. B.
Charging the battery with the charger (Fig. A)
1. Take the battery (4) from the machine.
2. Turn the battery (4) to upside down position
and slide it onto the charger (5) as shown in
6
CDA1131P
100-240VAC 50-60Hz, 50W
20V
2A
60 minutes
120 minutes
CDA1132P, CDA1133P
0.36 kg
Fig. A.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet
and wait for a while. The LED indicators on
the charger (6) will lighten up and show the
charger status.
The charger has 2 LED indicators (6) which
indicate the status of the charging process:
Red Led Status
Green led status Charger status
Off
Off
Off
On
On
Off
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the
charger plug from the outlet and remove the
battery from the charger.
When the machine is not being used
over a longer period of time it is best to
store the battery in charged condition.
4. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
Clean the charger casings regularly with a soft
cloth, preferably after each use. Make sure that
the ventilation openings are free of dust and
dirt. Remove very persistent dirt using a soft
cloth moistened with soapsuds. Do not use any
solvents such as gasoline, alcohol, ammonia,
etc. Chemicals such as these will damage the
synthetic components.
No power
Standby mode:
- No battery is
inserted or,
- Battery inserted
but charging has
finished
Battery charging in
progress
Publicidad
