Beta 7042LCD Manual De Uso E Instrucciones página 8

8
INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
OPERATION MANUAL AND INSTRUCTIONS FOR WELDING HELMET MANUFACTURED BY:
BETA UTENSILI S.P.A.
Via A. Volta 18,
20845 Sovico (MB)
ITALY
Original documentation drawn up in ITALIAN
CAUTION
Store the safety instructions with care and hand them over to the users.
PURPOSE OF USE
The welding mask can be used for the following purposes:
• manual arc welding, gas shielded arc welding
• plasma arc cutting
• grinding
The welding mask must not be used for the following purposes:
• use for laser welding or oxygen acetylene welding.
• use outside the technical specifications contained in the technical data table
• use in damp or wet environments or environments exposed to the weather
• use for any applications other than the stated ones
WORK AREA SAFETY
Do not operate the welding mask in environments containing potentially explosive atmospheres or inflammable materials,
because sparks may be generated, which can ignite the dust or fumes
Keep children and bystanders away from your workplace while using the welding mask. Distraction from other people can
cause you to lose control over the welding mask during use.
Do not inhale any gases or fumes while carrying out welding jobs.
Do not use any hard objects on the mask lens, to prevent the filter from being damaged.
WELDING MASK SAFETY
• Before use, check that the welding mask has not been damaged.
• When using the welding mask for the first time, check that the protective film has been removed from the interior and exterior
screen guards.
• Check that the power supply is adequate before use.
• Check that the guard has not been damaged; check that the solar cell and the arc sensor have not been damaged or blocked by dust.
• Check that no operating parts are worn off or damaged. Any scratched or broken parts should be replaced immediately, so as
not to incur any personal injury.
• Check that the filter is working correctly.
• Choose the right shade number according to machine type and welding current.
• To clean the welding mask, use a dry cloth or soft cotton, cleaning tissues or lens paper. Do not immerse the filter in water. Do
not use any corrosive solvents or detergent dilution petrol.
PERSONNEL SAFETY INSTRUCTIONS
• Stay alert; watch what you are doing. Do not use the welding mask while tired or under the influence of drugs, alcohol, or
medication.
• Carry out all operations in well-aired, dry rooms.
• Do not wear loose clothing, jewellery or metal objects when carrying out welding jobs.
• Replace the welding mask in a dry area, making sure not to damage it.
The welding mask alone does not protect you from all possible hazards arising from welding jobs. Additional personal
protective equipment may be required, depending on the values found in the environmental hygiene/risk analysis,
if the values exceed the limits under current regulations.
8
IMPORTANT! READ THIS MANUAL. FAILURE TO COMPLY
WITH THE SAFETY STANDARDS AND OPERATING
PROCEDURES MAY RESULT IN SERIOUS INJURY.
EN I