Tuner Module Installation - Clarion CMS 1 Manual De Usario E Instalación

5. TUNER MODULE INSTALLAION
1. Select an area with sufficient ventilation for the mounting of the tuner module in order to prevent
the module from overheating. You may mount the module in a horizontal or vertical position.
If the module is mounted in a vertical position, do not mount the module with the harness exit
points directly facing up to prevent water collecting in these areas.
2. Please refer to the diagram below for the mounting screw hole positions. Always use the
shortest length of screw possible.
3. During installation, use the 4 rubber mounting stoppers (included in the package) for the bottom
of the module. This provides clearance from surface moisture and provides sufficient ventilation
for the heat sink.
4. Extension wires/cables may be needed to route the harness and cable throughout the vessel.
Note: Retain some slack in the harness/ cables to prevent damage to the wires.
It is recommended relieve stress in all cables and harnesses.
5. Always read through the wiring diagram in this manual first, and follow all the wiring diagrams
carefully. The connections should be secured and insulated with crimp connectors or electrical
tape to ensure proper connections.
6. Once the wiring connections are completed, connect the negative terminal on the battery, turn
the vessel accessory ON and power on the unit to check if it is operating correctly.
If abnormalities occur, disconnect the battery negative terminal, recheck all wiring and try again.
Please refer to the troubleshooting section for assistance.
TUNER MOUNTING
14
CMS1
M4 TAPPING SCREW
4 PCS
RUBBER
STOPPER
4 PCS