Lorex Halo Serie Guía De Configuración Rápida página 6

EN - Camera Mounting
1. Use the mounting template to drill holes for screws, then insert the drywall anchors. Drill a hole for the
camera's cable if you plan to run it through the mounting surface.
2. Use the screws to mount the camera base to the surface. If you are running cables along a wall/ceiling, make
sure to pass the cable through the cable notch.
3. Feed the camera's cable through the camera base, then connect the cables (see page 12).
4. Loosen the adjustment screws and position your camera as needed, then tighten to secure it in place.
5. Remove the vinyl film from the camera lens once your installation is complete.
90°
9
Mounting Screw
Vis de montage
Tornillos de montaje
Drywall Anchor
Chevilles pour cloison sèche
Taquetes para yeso
Mounting Template
Gabarit de montage
Plantilla de montaje
Mounting Surface
Surface de montage
Superficie de montaje
10