Publicidad
Idiomas disponibles
Idiomas disponibles
&
WARNING:
TO AVOID
SERIOUS
INJURY,
BEFORE
PERFORMING
ANY
SERVICE
OR ADJUSTMENTS:
1. Depress
clutch/brake
pedal fully and set parking
brake.
2. Place
motion
control
lever in neutral
(N) position.
3. Place
attachment
clutch
in "DISENGAGED"
position.
4. Turn ignition
key to "STOP"
and remove
key.
5. Make sure the blades
and all moving
parts have completely
stopped.
6. Disconnect
spark
plug wire from spark
plug and place wire where
it cannot
come in contact
with plug.
TRACTOR
TO REMOVE
MOWER
Mower
will be easier
to remove
from the
right side of tractor.
1.
Place attachment
clutch in "DISEN-
GAGED"
position.
2.
Move attachment
lift lever forward
to
lower mower to its lowest
position.
3.
Roll belt off engine
pulley.
4.
Remove
small retainer
spring,
and
remove
clutch
spring
off pulley
bolt.
5.
Remove
large retainer
spring,
slide col-
lar off and push housing
guide out of
bracket.
6.
Disconnect
anti-sway
bar from chassis
bracket
by removing
retainer
spring.
7.
Disconnect
suspension
arms from rear
deck brackets
by removing
retainer
springs.
8.
Disconnect
front links from deck by
removing
retainer
springs.
9.
Raise lift lever to raise suspension
arms. Slide mower
out from under trac-
tor.
Small Retainer Spring
Clutch Spring
Small Retainer
Clutch Spring
Spring _
Retainer
Spring
IMPORTANT:
If an attachment
other than
the mower
deck is to be mounted
on the
tractor,
remove
the front links and hook
the clutch
spring
Into square
hole in frame.
TO INSTALL
MOWER
1.
Raise attachment
lift lever to its high-
est position.
2.
Slide mower under
tractor
with deflec-
tor shield
to right side of tractor.
3.
Lower
lift lever to its lowest
position.
4.
Connect
front links to mower
deck and
secure
with retainer
springs.
5.
Connect
suspension
arms to rear
deck brackets
and secure
with retainer
springs.
6.
Connect
anti-sway
bar to chassis
bracket
and secure
with retainer
spring.
7.
Push clutch
cable housing
guide
into
bracket,
slide collar onto guide
and
secure
with large retainer
spring.
8.
Place
flat washer
and clutch
spring
on
idler pulley bolt and secure
with small
retainer
spring.
9.
Install belt onto engine
pulley.
Flat Washer
• /;_+',
_-+_<C....
Square Hole
Jspenslon
+.
Engine
Pulley
Front Link
Anti-Sway
Bar
Collar
Retainer Springs
(Both Sides)
\
Deflector
Housing
Guide
Large Retainer
Spring
Bracket
22
Publicidad
