Descargar Imprimir esta página

Craftsman 536.885203 Manual Del Usario página 12

Publicidad

Idiomas disponibles

Idiomas disponibles

[o] -.1:1 ;__*_n
i [o_
gasoline that may be stale from long
periods of storage in the container.
_ll
ARNING: Gasoline is flam-
mable. Always use caution
when handling or storing
gasoline.
Do not fill fuel tank while snow
thrower is running, when it is hot,
or when snow thrower
is in an en-
closed area.
Keep away from open flame or an
electrical spark and do not smoke
while filling the fuel tank.
Never fill the tank completely.
Fill
the tank to within 1/4"-1/2" from
the top to provide space for ex-
pansion of fuel.
Always fill fuel tank outdoors and
use a funnel or spout to prevent
spilling.
Make sure to wipe up any spilled
fuel before stating the engine.
Store gasoline in a clean, ap-
proved container and keep the
cap in place on the container.
BEFORE STARTING THE ENGINE
1. Before you service or start the en-
gine, familiarize yourself with the
snow thrower. Be sure you under-
stand the function and location of all
controls.
2. Be sure that all fasteners are tight.
3. Before starting the engine, make
sure all controls operate correctly.
make certain that you have read the fol-
lowing information.
How To Start A Cold
Engine
1. Move the ignition lever to the on
position.
2. When starting the engine, do not
engage the auger drive ]ever.
3. Move the choke control to the FULL
choke position.
4. Push the primer button while cov-
ering the vent hale as follows: Re-
move finger from primer button
between primes.
Do not prime if temperature
above 50 ° F (10 ° C).
Push two times if temperature is
50 ° F (10 ° C) to 15°F (-10 ° C).
Push four times if temperature
is
below 15 ° F (-10 ° C).
Push five times if temperature is
below 0° F (-18 ° C).
5. Pull the recoil starter handle rapid-
ly (See Figure 7). Do not allow the
handle to snap back, but allow it to
rewind slowly while keeping a firm
hold on it.
Pull starter handle rapidly.
HOW TO STOP THE ENGINE
To stop the engine, move the ignition
lever to the OFF/STOP position.
HOW TO START THE ENGINE
(RECOIL STARTER)
Make sure that the engine has sufficient
oil. The engine is equipped with a recoil
starter. Before starting the engine,
F-031049C
12
Figure 7
6. As the engine warms up, move
choke control to 1/2 choke posi-
tion. When engine runs smoothly,
move choke lever to OFF Position.
NOTE: Allow the engine to warm up for
several minutes before blowing snow in
temperatures
below 0°R

Publicidad

loading