RHINO BABA-180M Manual De Uso página 5

Note. Avoid placing on a slippery surface.
Correct position
2.
Carefully step on the scale, it will turn on
automatically. Stay on the scale without
moving until the weight appears on the
screen, when the numbers on the display
flash 3 times and immediately remain fixed,
it will indicate your weight.
UNIT CONVESION
The unit change button is located on the
back of the scale [UNIT], as shown in the
diagram. With the [UNIT] button you can
change the unit of measure, from kilograms
(kg) to pounds (lb) and vice versa.
[UNIT]
Button
rear view
WARNING MESSAGE
Indicates that there is overweight on
the scale.
Indicates that the battery is low.
If the display shows the letter "C" after
being weighed, it means that the weight
shown on the screen has some error
and must be weighed again.
USE WARNING
1.
The glass of the scale can be very slippery
when wet.
2.
Stand tall while weighing yourself on the
scale.
3.
Do not hit or drop the scale.
4.
Handle the scale with care as it may
damage the accuracy of the scale.
5.
Clean the scale with a damp cloth but
avoid getting water inside the scale. Do
not use chemicals to clean it.
6.
Keep the scale on a cool, ventilated
surface.
7.
Always keep the scale in a horizontal
position.
8.
If the scale does not turn on, check that the
batteries are installed or the batteries may
be low. Replace batteries.
9.
If an error appears on the scale or the
scale does not turn on for a while, remove
the batteries for 5 seconds and then put
them back. If the problem continues,
contact your dealer.
10.
Do not use this scale for commercial
purposes.
4