Publicidad
Idiomas disponibles
Idiomas disponibles
collar to remove any dirt accumulation°
- Insert new filter into cover_.
• Put air filter cover and filter into collar
aligning the tab with the sloL
- Push in on cover and turn clockwise to
tighten.
MUFFLER
Inspect and replace corroded muffler as it
could create a
fire hazard and/or damager
SPARK PLUG
Change your spark ptug each year to
make your engine start easier and run
better.,Set spark plug gap at ,030 inch_
Collar_.
Slot
Air filter cover
Tum
counter--
lo
remove
Tum clockwise
to tighten
CLEANING
IMPORTANT=
For best performance,
keep mower housing free of built--up
grass and trash.. Clean underside
of
mower housing
after each use..
CAUTION;
D!sconnect spark plug wire
from spark plug and place wire where it
cannot come in contact with the spark
plug
• Turn lawn mower on its side.. Make sure
air filter and carburetor are up. Clean the
underside of your lawn mower by
scraping to remove build--u p of grass
and trash.,
° Clean engine often to keep trash from
accumulating. A clogged engine runs
hotter and shortens engine life.
• Keep finished surfaces and wheels free
of all gasoline, oil, etc..
• We DO NOT recommend using a
garden hose to clean lawn mower
unless the electrical system, muffler, air
tilter and carburetor are covered to keep
water out, Water in engine can result In
shortened
CAUTION:
Before performing any
service or adjustments:
,
Release control bar..
,
Make sure the blade and all moving
parts have completely stopped_
•
Disconnect spark plug wire from
spark plug and place where it cannot
come in contact with plug.
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in
the Operation section of this manual
REAR DEFLECTOR
The rear deflector, attached between the
rear wheels of your lawn mower, is
provided to minimize the possibilitythat
objects will be thrown out the rear of the
lawn mower into the operator's mowing
position,,
If the rear deflector becomes damaged, it
should be replaced.
TO ADJUST HANDLE
Your lawn mower handle can be raised or
lowered for your mowing comfort_ Four
(4) positionsare available: high. medium
high, medium low and low. Handles are
shipped mounted in the medium low
position°
° To change from medium low to medium
high position, the upper and lower
handle sections will have to be turned
over.
, Remove the cable clips.
= Remove the controls and operator
presence control bar from the upper
handler
• Remove hairpin cotters_
• Disconnect the lower handle from the
handle brackets.
° Turn the handle ever and reassemble
the hairpin cotters that have been
removed,
• Reassern'ble the controls and the
operator presence cont_6l bar to the
upper handle.
CAUTION: The operator presence control
bar must pivot freely to permit blade brake
engagement when control bar is released°
Do not over tighten the fasteners herding
the controls to the upper handle.
= To change from medium low to high
position only the upper handle section
will have to be turned over.
13
Publicidad
