Publicidad
Idiomas disponibles
Idiomas disponibles
4. Presetting the tyre pressure
Follow these steps to preset the tyre pressure:
1.
After the device is turned on, press the R button to
switch the unit of measurement between bar, psi or
kPa.
2.
Press the "+" or "-" button until the numbers start to
flash. Press the "+" or "-" button again to adjust to
the desired value. When the numbers stop flashing,
presetting of the tyre pressure is completed.
5. Pumping
1.
After connecting the gas tube and while the device is
turned on, press the Start button to start pumping. If
the pressure of the gas valve increases rapidly within
a short interval (80 psi in 3 seconds), it means that the
air way is obstructed. Please immediately turn off the
power, detach the rotary nozzle from the tire nozzle
and reconnect the gas tube.
2.
When the air pressure reaches the preset tyre
pressure, the pump will stop working. The pumping
operation is completed.
3.
Remove the car charger connector and the device will
automatically turn off.
6. Packing the device
After using the device, put the power cable and gas tube
in the wire box at the back of the device.
Coil the gas tube around the winding column once, after
reaching the start point, repeat the coiling one more
time, then pack it in the bottom wire box along the gas
tube groove. Close the wire box cover.
1
2
13
Publicidad
