Descargar Imprimir esta página

Craftsman 152.211640 Manual Del Usuario página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

Fig. C
G
H
E
C
................................... m
N
\
j
K
L
U
$
UNPACKING
AND CHECKING
CONTENTS
(Fig. C)
This Bench Grinder will require a minimal amount of
assembly, A 12mm x lOmm open end wrench is
provided for mounting the Tool Rest Assemblies and
the Spark Arrestor Assemblies,
1,
Remove parts from all of the cartons and lay them
on a clean work surface,
2,
Remove any protective materials and coatings from
all of the parts and the bench grinder, The protec°
tive coatings can be removed by spraying WD°40
on them and wiping it off with a soft cloth, This may
need to be redone several times before all of the
protective coatings are removed completely,
CAUTION: DO NOT use acetone, gasoline or
lacquer thinner to remove any protective coatings
on your bench grinder,
3,
Compare the items to Figure C; verify that all items
are accounted for before discarding the shipping
box, if there are any missing parts, call Customer
Helpline 1°800°897°7709,
To avoid serious injury, do not attempt to plug in the
power cord and turn "ON" the Bench Grinder if any
parts are missing, The Bench Grinder can only be
turned "ON" after all the parts have been obtained and
installed correctly,
The following items are to be provided in the shipping
box:
A,
Grinder (not shown)
B,
Eyeshield (2)
C, Carriage head screw M6 x 80mm (2)
D, Spacer (2)
E,
Fiat Washer M6 (2)
R
Eyeshield knob (2)
G, Wheel dresser
H, Hex head screw 5/16o18 x 1/2" (4)
I,
Fiat washer 5/16" (4)
J,
Spark arrestor, left
K,
Spark arrestor, right
L,
Fiat washer 1/4" (2)
M, Hex head screw 1/4o20 x 1/4" (2)
N, Tool rest support, left
O, Tool rest support, right
R
Tool rest, right
Q, Drill bit sharpening plate
R, Tool rest knob (2)
S,
Fiat washer 5/16" (2)
T,
Tool rest, left
U, Special wrench

Publicidad

loading